![]() ![]() It is much worse when a bad adapter pretends to be good, but sends garbage to the car or corrupts the data read from the car. If a bad adapter doesn’t allow you to read or encode anything, that’s good. Once again I repeat: the quality of the adapter is important. Coding and Service -> Backup.ħ) What’s wrong with my adapter? It can connect and read some data, but doesn’t let me read coding state and code anything. I strongly recommend that you back up all blocks before making any changes. Therefore, I advise: if you do not know by 100%, methodically roll back everything. The most common mistake is that people think: the problem is caused by some specific coding, but in fact it is caused by another, earlier one (let’s say they performed 10 encodings, found that something went wrong, and think on one of the latter, although the problem is real at the very beginning). Moreover, this should be done chronologically from the newest to the oldest points. All you need is to methodically restore operations from your coding history. What to do?Īlmost all operations and the initial state of codings are stored in the encoding history. By the method of exclusion, we discard one of the reasons and we are left with one reason: the coding is simply not supported by your car.ĥ) I did something and now I have something wrong. If the adapter allows you to use other encodings, then it is logical to conclude that the problem is not in it. You are shown two possible reasons: either the coding is not supported, or the problem is in the adapter. Sounds funny, but it’s true.Ĥ) In the current state of the coding, it says “Coding is not supported or faulty ELM327 device”, although other codings are applied normally. ![]() Second, on many cars from 2021 onwards to apply the new value, you must open the hood and activate the handbrake. Models are indicated there.ģ) The current state of codings is read normally, but an unknown error occurs when trying to code any option. Under the “Coding and Service” section at the top, there is a platform selection. In order for the “Coding and Service” item to appear, you need to: select one of the connection profiles for Audi, Volkswagen, Skoda, Seat (which one is not important) and connect to the car.Ģ) How do you know if I have MQB or PQ26 or MLB-EVO? I will try to create a small FAQ on this topic with solutions to the most common problems.ġ) “Coding and service” does not appear. I am very often asked the same questions related to the coding of VAG group cars (Volkswagen, Audi, Skoda, Seat). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |